– 3.6 –
1) Check details with guide display.
2) Install the ink cartridge.
3) If the error recurs after the ink
cartridge has been installed.
Conduct sensor tests to find out the
cause of trouble.
Possible causes of the troubles are as
follows.
a) The cartridge presence/absence
sensor has failed.
b) Defective contact or disconnection
of relay cables.
c) Main PCB or IO PCB has failed.
1) Replace the ink cartridge with a new
one.
2) If the error recurs after the ink
cartridge has been replaced, conduct
sensor tests to find out a possible
cause of the trouble.
Possible causes of the troubles are as
follows:
a) The ink end sensor has failed.
b) Defective contact or disconnection
of relay cables.
c) Main PCB or IO PCB has failed.
1) Check jut of the near end detection
plate of ink cartridge.
2) Upgrade F/W Ver.5.0 more.
1) Replace the ink cartridge with a new
one.
1) Replace the new ink cartridge.
1) Check deformation of the junction of
unit side and contact failure.
2) Check mounting of ink IC chip.
3) Replace the new ink cartridge.
1) Replace the new ink cartridge.
• The number of absent
ink cartridge is shown.
• Cartridge with
defective IC chip is
displayed.
• The number of the ink
cartridge in which the
ink has run short.
•Wrong value by a near
end plate
• Ink has run out
• The ink cartridge will
expire soon or has
expired.
• The IC chip missing,
Inferior contact.
• The OEM ink cartridge
has been installed.
• The IC chip of the ink
cartridge cannot be
read normally.
• The third party ink
cartridge has been
installed.
Message Description
Corrective measures and
recovering procedures
< LOCAL >
CARTRIDGE K - - - - - - -
< LOCAL >
NEAR END K K - - - - - -
< LOCAL >
INK END K - - - - - - -
< LOCAL >
timeLIMIT KKMMCCYY
NON-ORIGINAL INK
KKMMCCYY
WRONG INK IC
KKMMCCYY
3-2-2. Ink-related components and other components
To Next Page
Loading...
Need help?
General