MIMAKI JV3-160SP User Manual

– 5.37 –
5-4-2. PARAMETER DRAW
[Function]
Setting state of parameters is plotted.
[Operation]
1) Select the “TEST”.
Press the
ENTER
key.
2) Select the “PARAMETER DRAW” pressing
the
FUNCTION
key.
Press the
ENTER
key.
3) Select the plot parameter using the
or
key.
SYSTEM PARAMETER
INK PARAMETER 1
INK PARAMETER 2
INK PARAMETER 3
MENT PARAMETER
SERVO PARAMETER
ADJUST PARAMETER
INFO PARAMETER
4) Press the
ENTER
key to start plotting.
HEAD ID is issued in the maintenance list in case maintenance mode is released.
FUNCTION
# TEST < ENT >
# TEST
PARAM. DRAW< ent >
# PARAM. DRAW
DRAW : SYSTEM PRM

MIMAKI JV3-160SP Specifications

General

Maximum Print Width	1600 mm
Power Requirements	AC 100-240V, 50/60Hz
Technology	Solvent
Printing Method	Piezoelectric
Print Resolution	1440 x 1440 dpi
Ink Type	Solvent ink
Ink Colors	CMYK
Media Types	banner
Media Thickness	Up to 1 mm
Interface	USB