MIMAKI JV3-160SP - 4-1. Maintenance Flow by Replacement Parts

– 4.3 –
4-1. Maintenance Flow by Replacement Parts
When an important part is replaced, perform adjustment according to the Maintenance flow.
Important maintenance item for JV3
Print head Cap slider assy S dumper assy S pump assy Main PCB X motor
replacement replacement replacement replacement replacement replacement
Periodical replacement OOO O
S pump assy Replace
S dumper Replace
X motor Replace
Coupling Adjust
Parameter :U-LODE Execute
Main PCB Replace
F/ W Ver.up
Parameter :D-LODE Execute
Cap slider Replace
Head BKT height
Washing fluid Discharge
Head unit
Head Replace
Head unit base
Station assy
Capping position Check
Head ID Enter
Fill up solvent ink Execute Execute Execute
Nozzle check Perform Perform Perform
Head slant adjustment Perform Check
PRINT ADJUST2 Execute Check
Check method Check Perform Check Check Check Check
with image Cleaning or Filling discharge discharge operation of with image
for confirmation condition condition failed locations