– 4.2 –
• Refer to the MECHANICAL DRAWING for disassembly drawings.
• The following parts are dedicated for JV3 (Solvent) ink supply.
Do not use parts of other models. Using water-based parts may result in
dissolution or distortion.
1. S Print head assy (M004905)
• The AD Plate (head mount plate) is a plating product.
• The HEAD ID is provided with " • • • • • •" display.
2. S Damper L assy 2 (M006347)
•The damper is large type.
S Damper assy (M004902)
········Only 75SPII model
• The damper is small type.
3. Cap slider 4H assy (M005248)
S Cap assy (M004908)
• The Connection tube to the pump is transparent.
4. S Pump assy (M004868)
• The Pump tube is transparent.
5. Solvent Wiper (SPA-0116)
• The Wiper is white.
6. S Cartridge flame assy
• The O ring of the wire is blue.
( Judgement from appearance is not possible.)
7. O ring at the ink supply joint
• RS O ring for Ø2 tube Ø2.16 x 1.4 (M700326) -Blue
• RS O ring Ø3 tube Ø2.9 x 1.4 (M700325) -Blue
CAUTION
• To prevent the ink from getting into your eyes, be sure to wear safety goggles and
gloves when replacing or adjusting a part which may cause ink leakage. If the ink
sticks to your hand, the skin may be damaged.
To Next Page
Loading...
Need help?
General