– 3.17 –
3-3-10. Abnormal wiper operation
Problems The wiper does not work.
Causes 1) Loose screw. (Tighten a gear.)
2) The shaft is stained.
3) Motor and other parts defect.
Checking procedure 1-3) Visually confirm the wiper status.
Remedies 1) Fasten the screw.
2) Clean the wiper assy and shaft.
3) Replace the defective parts.
3-3-11. Abnormal heater temperature
Problems It takes too long for the heater to reach the set temperature.
Causes 1) The operating voltage is 100 to 120 VAC but the voltage selector of the
heater is set to 220 V.
2) The operating environmental temperature is low and the set temperature
is too high.
Checking procedure 1-2) Visually confirm the heater.
Remedies 1) Set the switch correctly.
2) Use the device within the limit of Heater set temperature < Operating
environment temperature +30
o
C >. (Recommended : 20
o
C or more)
To Next Page
Loading...
Need help?
General