MIMAKI JV3-160SP User Manual

– 5.3 –
5-2. Entering into the maintenance mode
The maintenance mode is entitled in two different methods.
5-2-1. Entering into the maintenance mode when actuating the plotter
This section explains how to enter into the maintenance mode when turning on the power to
the plotter. The maintenance mode is closed by re-turning the power on.
< Method 1 >
1) Turn the power on. When the firmware
version number is shown on the LCD, press
the
REMOTE/LOCAL
key while pressing the
FUNCTION
key.
• If simultaneously pressing the
FUNCTION
key and
REMOTE/LOCAL
key, the
plotter may enter into the firmware
updating mode, then returning the
power in this case.
• Do not turn off the main power
during displaying Firmware version
number, or It may cause crashing
of the proglam in the Flash
memory.
2) Select the detection of media using the
key, key or key.
3) After the detection of media, the plotter will
enter the LOCAL mode.
4) Press the
FUNCTION
key in repetition, and the
maintenance items will appear on the LCD.
The item name attached with a number sign (#)
are the maintenance items.
BOOT
v ∗ . ∗ ∗
MEDIA SELECT
ROLL < > LEAF
< LOCAL >
w i d t h : ∗ ∗ ∗ ∗ mm
FUNCTION
SET UP < ENT >
FUNCTION
MAINTENANCE < ENT >
FUNCTION
DRYING FAN < ENT >
FUNCTION
DISPLAY < ENT >
FUNCTION
# ADJUST < ENT >
FUNCTION
# TEST < ENT >
FUNCTION
REMOTE/LOCAL
+

MIMAKI JV3-160SP Specifications

General

Brand	MIMAKI
Model	JV3-160SP
Category	Plotter
Language	English