Mindray A9 Service Manual

6-61
Failure
Description
Possible Cause Recommended Action
sampling point.
5. Replace the internal AG
module.
6. Replace the electronic
vaporizer.
00000040 The system exits the standby state. During calibration, the system exits
the standby state.
00000080 The linearity does not meet the
requirement.
1. Check whether the gas supply
is sufficient.
2. Check whether the water trap
and sampling line of the AG
module are connected
properly and whether leakage
occurs.
3. Check whether leakage occurs
in the internal pipeline of the
machine so that the fresh gas
cannot flow through the
sampling point.
4. Replace the internal AG
module.
5. Replace the electronic
vaporizer.
00000100 The system fails to write data into
EEPROM.
Replace the electronic vaporizer.
00000200 The electronic vaporizer is
automatically turned off due to an
error.
Perform diagnosis based on the
fault code of the electronic
vaporizer.
00000400 The measured value of the AG module
exceeds the upper limit during
verification.
1. Calibrate the electronic
vaporizer again.
2. Check whether the water trap
and sampling line of the AG
module are connected
properly and whether leakage
occurs.
3. Check whether leakage occurs
in the internal pipeline of the
machine so that the fresh gas
cannot flow through the
sampling point.
4. Replace the AG module.
00000800 The measured value of the AG module
exceeds the lower limit during
verification.
1. Calibrate the electronic
vaporizer again.
2. Check whether the water trap
and sampling line of the AG
module are connected

Mindray A9 Specifications

General

Brand	Mindray
Model	A9
Category	Medical Equipment
Language	English