19-9
In this review window:
Before reviewing full-disclosure waveforms, your monitor must be equipped with an
external storage card (only the CF storage card is supported so far) and you need to
save waveforms first. To review full-disclosure waveforms, select [Save Waves >>]
and then select the parameters whose waveforms you want to view.
You can set the start time of the trends you want to view by selecting [Start Time].
You can select a waveform you want to view from either parameter combo box.
To view the waveforms, you can either:
Select or beside the [Scroll] button to move the cursor one step left or right
to navigate through the waveforms, or
Select or to move the cursor one page left or right to navigate through
the waveforms.
A time indicating your current position is displayed above the cursor. Measurement
numerics corresponding to the cursor location are displayed at the left side of the
[Waveforms] window, and change as the cursor is moved.
You can change the wave gain by selecting [Gain] and then selecting the appropriate
setting. The number of waveforms displayed in this window is subject to the wave
gain.
You can change the waveform sweep speed by selecting [Sweep] and then selecting
the appropriate setting.
By selecting the [Record] button, you can print out the first three waveforms and
measurement numerics by the recorder.
By selecting the [Print] button, you can print out the waveforms and measurement
numerics by the printer.
To Next Page
Loading...
