24-2
24.2 Installing or Replacing a Battery
The patient monitor uses two battery packs. One battery pack can be easily exchanged while
the monitor operates from the other. If the patient monitor uses one battery pack, you should
insert a new battery pack before the old one depletes.
To install or replace a battery, follow this procedure:
1. Open the battery door.
2. Push aside the latch fixing the battery to be replaced and remove the battery.
3. Insert a battery into the slot with its face up and its contact point inward. Then restore
the latch to the original position.
4. If necessary, repeat the steps above to replace the other battery.
5. Close the battery door.
To Next Page
Loading...
