6-2
6.1.4 Changing Parameter and Waveform Colors
1. Select [Waveform] in configuration mode.
2. In the [Parameter/Wave Color] area, you can set color for each parameter and
waveform. Selecting [Next Page] allows you to set color for more parameters and
waveforms.
6.1.5 Selecting Waveforms for Display
Your can select waveforms for display on the screen:
1. In the main menu, select [Others >>]→[Wave Setup >>]→[Select Waves >>].
2. In the [Select Waves] menu, select the waveforms you want for display on the screen.
3. Select [Exit]. Your selections will take effect automatically.
Additionally, you can change the order the waveforms are displayed on the screen if needed.
1. In the main menu, select [Others >>]→[Wave Setup >>].
2. In the [Wave Sequence] menu, you can sequence the waveforms displayed on the
screen.
3. Select [Exit]. Your change will take effect automatically.
Select [Screens] in configuration mode, and you can also change the order in which all
waveforms are displayed on the all parameters screen.
6.1.6 Changing Screen Layout
1. In the main menu, select [Screen Layout >>].
2. Select a normal screen, such as all parameters screen, big numerics screen, etc.
3. You can also select a split-screen functional view if necessary, such as minitrends,
others, etc. But the functional view is available only with the all parameters screen.
You can select [Screens] in configuration mode and select your desired screen. Then, your
selected screen will be displayed when the configuration is applied.
To Next Page
Loading...
