3-9
NOTE
z Data may be unable to be saved into the CF storage card shortly after the card is
inserted.
z If no CF storage card is used or the card has been removed, all the data saved will
get lost in case that the monitor shuts down or a sudden power interrupt occurs.
z Admitting too many patients will affect the read-write speed of the CF storage
card. Please clear the patients’ data in time.
CAUTION
z Unload the CF storage card before removing it from the patient monitor.
Otherwise it may cause damage to the data in the card.
z Use only the CF storage card specified by Mindray.
3.7 Using an External Display
An external display, showing the same screen as the host display, can be connected to the
monitor through the video output connector, for viewing only.
The recommended specification is as below.
External display
Screen type Medical-grade VGA monitor
Resolution 800×600 pixels or above
EMC MPR II, CISPR 11B
Third certificate UL, C-UL, TUV, CE, FCC
3.8 Changing General Measurement Settings
This chapter covers only general measurement settings in monitoring mode. Other specific
measurement settings can be referred to in respective sections.
3.8.1 Switching On/Off Modules
You can switch on or off measurement modules as required.
In the main menu, select [Others>>]→ [Module Switch]. Select parameters for measuring,
and then select [Exit] to save the settings.
To Next Page
Loading...
