22-3
22.5 Stopping Report Printouts
To stop report printouts, select[Print Setup >>]→[Stop All Reports] in the main menu.
22.6 Setting Up Reports
22.6.1 Setting Up ECG Reports
You can print out ECG reports only under full-screen, half-screen or 12-lead monitoring
screen. To set up ECG reports, select [Print Setup >>]→[ECG Reports >>] in the main
menu.
[Amplitude]: set the amplitude of the ECG waveforms.
[Sweep]: set the wave print speed.
[Auto Interval]: If [Auto Interval] is set to [On], the system will automatically adjust
the space between waveforms to avoid overlapping.
[Gridlines]: choose whether to show gridlines.
[12-Lead Format]: If you select [12X1], 12 waveforms will be printed on a paper from
top to bottom. If you select [6X2], 12 waveforms will be printed from left to right with 6
waveforms on each side and a rhythm waveform will be printed at the bottommost.
22.6.2 Setting Up Tabular Trends Reports
To set up tabular trends reports, select [Print Setup >>]→[Tabular Trends Reports >>] in
the main menu.
Start time: You can set a time period whose trend data will be printed out by setting
[From] and [Back]. For example, if you set [From] as 2007-4-2 10:00:00 and [Back] as
[2 h], the outputted data will be from 2007-4-2 08:00:00 to 2007-4-2 10:00:00. In
addition, the [Back] can be set to either:
[Auto]: If [Report Layout] is set to [Time Oriented], the report will be printed by
time. If [Report Layout] is set to [Parameter Oriented], the report will be printed
by parameters.
[All]: If you select [All], all trend data will be printed out. In this case, it is no need
to set [From].
[Resolution]: choose the resolution of the tabular trends printed on the report.
[Report Layout]: If you select [Time Oriented], the report will be printed by time. If
you select [Parameter Oriented], the report will be printed by parameters.
To Next Page
