21-4
21.4.3 Setting the Realtime Recording Length
The recording time depends on your monitor’s settings when a realtime recording is started.
In the [Record Setup] menu, select [Realtime Rec. Length] and toggle between [8 s] and
[Continuous].
1. [8 s]: record 8-second waveforms from the current moment.
2. [Continuous]: record the waveforms from the current moment until stopped manually.
21.4.4 Setting the Interval between Timed Recordings
Timed recordings start automatically at preset intervals. Each recording lasts 8 seconds. To
set the interval between timed recordings, in the [Record Setup] menu, select [Interval] and
then select the appropriate setting.
21.4.5 Changing the Recording Speed
In the [Record Setup] menu, select [Paper Speed] and toggle between [25 mm/s] and [50
mm/s].This setting is for all recordings containing waveforms.
21.4.6 Switching Gridlines On or Off
In the [Record Setup] menu, select [Gridlines] and toggle between [On] and [Off].
1. [On]: show gridlines when recording waveforms.
2. [Off]: hide gridlines when recording waveforms.
This setting is for all recordings containing waveforms.
21.4.7 Clearing Recording Tasks
In the [Record Setup] menu, select [Clear All Tasks]. All queued recording tasks are cleared
and the current recording is stopped.
21.5 Loading Paper
1. Use the latch at the upper right corner of the recorder door to pull the door open.
2. Insert a new roll into the compartment as shown below.
3. Close the recorder door.
4. Check if paper is loaded correctly and the paper end is feeding from the top.
To Next Page
Loading...
