23-2
23.3 Transferring Data
You can transfer the patient data saved in the monitor to a PC via a crossover network cable
or an external storage card, or within a LAN for data management, review or print.
23.3.1 Data Export System
You must install the data export system on the intended PC before performing the data
transfer operation. Refer to the document accompanying the installation CD-ROM for
installation instructions.
The data transfer feature also supports patient management, data review, data format
conversion, print, etc. Refer to the help file of the system software for more details.
23.3.2 Transferring Data by Different Means
NOTE
z Never enter the data transfer mode when the patient monitor is in normal
operation or performs monitoring. You must re-start the patient monitor to exit
the data transfer mode.
Transfer data via a crossover network cable
Before transferring data using a crossover network cable, do as follows:
1. Connect one end of the crossover network cable to the patient monitor and the other end
to the PC.
2. Set the IP address of the PC. This IP address must be in the same network segment with
that of the patient monitor.
3. Make sure that the data export system is active on the PC.
Then, follow this procedure to transfer data:
1. In the main menu, select [Archives>>]. You may need a password to enter the
[Archives] menu, depending on the [Archives Access] setting in configuration mode.
Then select [Export Data] from the [Archives] menu.
2. Select [Yes] from the popup message box and enter the [Data Export] window.
3. Input the IP address already set on the PC.
4. Select [Start] to start transferring data.
To Next Page
Loading...
