To Next Page

To Previous Page

Care and Maintenance 9-5

3. Clean control panel

 Tools: dry soft cloth, mild soapy water

 Method:

Use dry soft cloth to clean the surface of the system. If the system is dirty, moisten the soft

cloth with mild soapy water and wipe off any stains. Use dry soft cloth to remove any moisture

and allow all hard surfaces to completely air-dry. If it is difficult to clean the control panel,

disassemble the keys first and then use mild soapy water to clean it.

NOTE:

Keyboard on the control panel should be cleaned periodically; otherwise, keys maybe

blocked by dirt and buzzer dings, keys don’t work.

4. Clean Probe

 Tools: mild soapy water , dry soft cloth , soft brush

 Method:

a) Wipe out the dust attached to surface of probe, and check if it has any abnormality

such as crack;

b) Remained stain or dust attached to surface of probe cable should be washed out by

cloth with clear water or soapy water, and then air-dry the surface of probe cable;

c) Use a soft brush to clean the probe holder, removing dust simultaneously.

5. Clean Holders

 Tools: mild soapy water , dry soft cloth Method:

a) Wipe out the dust attached to surface or inner of probe holder,

b) Remained stain or dust attached to probe holder should be washed out by cloth with

clear water or soapy water, and then air-dry the surface of probe cable.

6. Clean the Cover

 Tools: dry soft cloth, soapy water

 Method:

Use dry soft cloth to clean the cover of the system. If the system is dirty, moisten the soft

cloth with mild soapy water and wipe off any stains, then air-dry.

Note: Be sure to use soft brush to brush the dust attached to all the sockets or interfaces which

can be seen (such as probe sockets, sockets or interfaces in IO panel and power supply

panel),not the cloth with water.

Mindray Z6 Service Manual

Other manuals for Mindray Z6