System Installation 3-5
3.2.2 Checking
1. After unpacking, check the objects in the container with the package list to see if anything is in
short supply or is wrong.
2. Inspect and make sure there is no damage to the machine, no indentation, no cracks.
3.3 Installation of Main Unit
3.3.1 Installing Battery
As shown in the following figure.
1. Open the battery cover and put the battery near the bay (Note that the battery shall be put
in correct direction).
2. Push the battery into the battery bay ①, and push to the right side as ② until it’s tightly
locked.
3. Close the battery cover.
Figure 3-1 Installing Battery
To Next Page
Loading...
