0 0 0 0 0
Data bit length
Parity bit
Stop bit
Baud rate
Terminator
0 : 7 bit, 1 : 8 bit
0 : No parity
1 : Even parity
2 : Odd parity
0 : 1 bit, 1 : 2 bit
0 : 1 200 bps, 1 : 2,400 bps
2 : 4 800 bps, 3 : 9 600 bps
4 : 19 200 bps 5 : 38 400 bps
0 : CR, 1 : CR + LF
16-2-1. Operation mode
Operation mode is selected by the setting of function F-40.
Setting range : 0 or 1
0 : Command mode
1 : Stream mode
16-2-2. Output target in Stream mode
The output target in stream mode is selected by the setting of function F-41.
Output target is effective when the set value : [1] is selected by function F-40.
Setting range : 0 ~ 3
0 : Display interlocked
1 : Gross value
2 : Net value 3 : Load display data with condition
16-2-3. Specifications of communication
Specifications of communication are selected by the setting of function F-42.
Setting range : 00000 ~ 15121
：13020
Function No. Set value Contents
F-41
00000
~ 15121
16-2-4. Addition of decimal point to transmission data
The presence of transmission data decimal point is selected by the setting of function
F-46.
When you select the set value : 1 (with decimal point), a decimal point is put in the decimal
point display position specified by C function CF-01 (Decimal point display position).
Setting range : 0 or 1
0
: No decimal point
1 : With decimal point
16-2-5. Number of digit for unit
The number of digit for unit of transmission data is set by function F-49.
This becomes effective when the set value : [3] (Load display data with the condition) is
selected by function F-40.
Setting range : 0 or 1
0 : 2 digit of unit
1 : 3 digit of unit
112
USB (RS-232C)
To Next Page
Loading...