55
Setting of Function
8-9. Maintenance date, Maintenance number
Please do not use because F-90 and F-91 are functions for our maintenance.
8-10. Lighting time of liquid crystal back light
Lighting time of liquid crystal back light is set by function F-95.
When the set time has passed since the key was operated at the end, back light of liquid
crystal is turned off.
Setting range：00 ~ 60
：00
Unit：1 minute Lighting always：00
8-11.Function clear
Function clear is executed by function F-99.
The set value of the function is returned to default.
By pushing
key in the display condition of , becomes blinking.
At this time, please push
if you want to discontinue a clear memory.
The display becomes
, and clear memory is not executed.
By pushing
key during the display of blinking, displays and a
operation of clear memory is completed.
• F-90 and F-91 are functions for our maintenance, and these are not cleared by the
memory clearness execution.
• Please do not change in the set value under the measurement because the A/D
sampling rate decreases temporarily while rewriting the set value.
• Back light is turned on again by pushing either of key at the liquid crystal
backlighting shut off.
To Next Page
Loading...