56
Setting of Function
9. S function mode
The changeover of measurement mode, the changeover of control mode, the operation of
comparison signal, the comparison operation of near zero, the comparison operation of full are
set in S function mode. Please refer [11. Measurement mode] for the details of measurement
mode and control mode.
9-1. Setting method of S function mode
Measurement mode
▲
5
１
By pushing key from normal measurement mode,
displays.
3
Select the digit to be changed.
Change the value of digit to be changed.
Memorize the displayed value, and proceed to the next step.
Return to the display of .
4
2
Push the key twice.
The display changes in order of → →
→ , and you can enter into S function mode.
By pushing key, displays.
Select S function number you want to change.
The operation of key is as same as .
Push the key. Please change the setting value of S function
number selected.
3
In the same way, please select the changed S function number
continuously
when you change the setting of other S function numbers.
By pushing
key after completing that memorize, displays.
By pushing key again, you can return to the measurement mode.
Push the key. The changed contents is memorized and
the next S function number is displayed.
CAL-ZCAL-Z
FUNC.FUNC.
ENTERENTER
FF
CAL-ZCAL-Z
CAL-SCAL-S
FUNC.FUNC.
ENTERENTER
FF
ENTERENTER
FF
ENTERENTER
FF
FUNC.FUNC.
FUNC.FUNC.
• Please do not change in the set value under the measurement because the A/D
sampling rate decreases temporarily while rewriting the set value.
To Next Page
Loading...
Need help?
General