IV
3. Power supply
4. Instruction for usage
Caution
• Be sure to ground a grounding wire.
If a grounding wire is not grounded, it may cause malfunction of the instrument or an electric
shock to an operator.
• Before using a new instrument, or when exchanging a strain gage applied transducer
for a new one, be sure to make calibration. If neglected, it may cause incorrect results in
measurement or malfunction in the instrument and moreover may cause d
amage to peripheral
equipments. When similar trouble occurs after calibration, be sure to make calibration again,
even if calibration has completed.
• When using the instrument, check that wires are connected properly. If neglected, correct
measurement cannot be obtained and it may cause malfunction in the instrument or cause
damage to peripheral devices or a critical accident.
• Improper change of
setting during operation may cause incorrect measurement or
malfunction, or cause damage to peripheral equipments.
• Do not give the instrument such a shock as throwing something at it. It may cause damage or
destroy electrical circuits and even have loose resistance to environment or operability.
• Do not remove the cover of the case of the instrument, nor peel off the panel sheet nor take
the inst
rument into pieces. If neglected, it may cause damage to the case and the panel
sheet and even have the possibility of damage to resist to environments or operational
performances.
Caution
Warning
• Be sure to check that power supply is OFF when installing each cable. If an operator works
with power ON, operator may have an electric shock or the instrument may be destroyed.
• Before supplying power, check the indication of power voltage/specifications to be identical
with supplied power. If they are not identical, contact with Minebea. Without checking the
above, operation may cause d
amage to the instrument or electric shock.
To Next Page
Loading...
Need help?
General