35
Setting of Function
5. C function mode
By setting of C function, the setting of the function related to the calibration, and changeover
of valid / invalid is executed.
5-1. Setting method of C function mode
Measurement mode
１
2
3
4
5
By pushing key from the normal measurement mode,
displays.
By pushing key, displays.
Please select the number of C function that you want to change.
Push key. The changed contents has been memorized,
and the next function number is displayed.
When you will change the other setting of C function, please select
the number of C function continuously by the same step as above.
By pushing key after memorized, displays.
By pushing key again, you can return to measurement mode.
Select the changing digit.
Change the value of the changing digit.
Return to display.
Memorize the display value, and proceed to next step.
Push key. Please change the set value of C function number
that you select. The key operation is as same as Step .
3
▲
By pushing key, displays and you can enter into
C function mode.
FUNC.FUNC.
ENTERENTER
FF
CAL-ZCAL-Z
CAL-ZCAL-Z
CAL-SCAL-S
FUNC.FUNC.
ENTERENTER
FF
ENTERENTER
FF
ENTERENTER
FF
FUNC.FUNC.
FUNC.FUNC.
To Next Page
Loading...
Need help?
General