Minebea CC-Link CSD-892-73 - Page 45

34
Calibration
4-10-4. SPAN mode
The setting of weighing capacity and mass of weight, and span calibration by reading the
load cell output value is executed by pushing
CAL-ZCAL-Z
key for 2 seconds or more.
4
By pushing key after the setting, displays.
F
ENTER
2
Select the changing digit.
Change the value of changing digit.
Interrupt the setting, and return to measurement mode.
Memorized the displayed value, and shift to next step.
3
Please set the weighing capacity.
6
Measurement mode
7
By pushing key after the setting, blinks.
:HLJKWLQJYDOXH
PHPRUL]HGQRZ
6HWXSZHLJKLQJ
FDSDFLW\
Mass of weight for
weighing capacity.
Set-up value of weight
* The weighing capacity memorized at present is displayed.
5
F
ENTER
* The mass of weight memorized at present is displayed.
8
9
All the setting is memorized after blinks for 2 seconds,
and you can return to the measurement mode.
Set the mass of weight. The key operation is the same as .
2
By pushing key from , displays.
Please put the weight on the measuring section set by .
Please push after lights on.
5
STABLE
By pushing key from , displays.
Measurement mode
ڸ
1
By pushing key from the normal measurement mode,
blinks.
CAL-SCAL-S
CAL-SCAL-S
CAL-ZCAL-Z
CAL-SCAL-S
FUNC.FUNC.
ENTERENTER
FF
ENTERENTER
FF
ENTERENTER
FF
Push for 2
seconds or more
ENTERENTER
FF