14
Change of mode
① Function mode
The setting concerning the following functions and
effective/invalid are changed.
• Various filter
• Key lock
• Detection of stability
• Hold
• Set of action for five steps comparator
• Allocation of function to [F/ENTER] key.
• External control I/O
• Time of liquid crystal back light on
• Various interface
• Function clear
② C-Function mode
The setting concerning the following functions and
effe
ctive/invalid are changed.
• Decimal point display position
• A/D sampling
• Overload display
• Comparative action display synchronization
• Unit
• ZERO set
• ZERO tracking
• Power-On-Zero
• Tare weight cancellation
• Gravity acceleration compensation
• Change of data saving location
• Clear of digital linearization.
• Stability detecting time width at calibration
• C-function clear
③ S-Function mode
The setting concerning the following functions and
effective/invalid are changed.
• Measuring mode
• Control mode
• Signal of comparative action
• Comparative action at near zero
• Comparative action at full
• S-function clear
④ Calibration mode
Calibration is processed to display the electrical signal
from the measuring part (load cell) as an accurate weight.
⑤ Check mode
This operation checks the condition and movement of this unit.
• Shift to EzCTS mode
• Confirming the ROM version
• Confirming the movement of external control I/O.
• Confirming the load cell output value
⑥ Measurement mode (Comparator setting mode)
Setting of measurement value at simple comparison mode and
comparative value of five steps comparator mode is processed.
（FUNC）
（CFUNC）
（CAL）
（COMP）
（CHECK）
（SFUNC）
To Next Page