Mitsubishi Electric 3F-14C-WINE - Page 125

11-125 11-125
Tab
Group
Button
Explanation
Menu
item
Start/Stop
Debug start
Reopens the program being edited in the debug
mode.
11.11.1
Debug stop
Reopens the program in the debug mode in an
editable state.
11.11.6
Breakpoint
Set...
Sets a breakpoint in a program opened in
debugging status.
11.11.4
Delete
Deletes a breakpoint in a program opened in
debugging status.
Delete all
Deletes all breakpoints in a program opened in
debugging status
Show
Show the
executed
line always
Sets display/non-display the executed line in the
program opened in debugging status.
11.11.1
Tool
*
Command line
Renumber
The renumbering function can only be used with
MELFA-BASIC IV and Movemaster commands.
Batch-renumbers line numbers.
11.7.4.17
Sort
The sorting function can only be used with
MELFA-BASIC IV and Movemaster commands.
Sorts edited programs in line number order.
11.7.4.18
Position variable
Batch edit
XYZ
variable
Changes the position variables in the program being
edited in a batch and can sum up all the values
11.7.4.16
Joint
variable
Work
coordinate
variable
Tact time
Calculation
Run
calculation
Tact time calculation can only be used in a
simulation.
You can calculate the tact time of the program.
20.3
Other
Option
You can customize the syntax check before saving
for example.
11.6
* When the program is opened in the debug mode, the [Tool] tab is not displayed.