11-124 11-124
Separates and displays the command editing
screen.
Collapses and displays all command blocks.
Expands and displays all command blocks.
Edit the selected position variable.
Delete the selected position variable.
Select the robot to be used in the "Get current Pos."
and "Pos. Jump".
Get the current position of robot to selected position
variable.
Move the robot to the coordinates of selected
position variable.
Copies the position variable.
Pastes the copied position variable.
Redoes the editing operation on the position
variable.
Undoes the edited location of the position variable.
Searches for the specified character string.
Replaces the specified character string with another
character string.
Searches for the specified character string in the
program files.
Adds a bookmark to the selected program line.
Deletes a bookmark from the selected program line.
Deletes all bookmarks from the program.
Jumps to the line set with a bookmark immediately
before the cursor.
Jumps to the line set with a bookmark immediately
after the cursor.
Writes all lines of the program to the robot controller.
This cannot be used when the program is opened in
2
Writes the selected program lines to the robot
controller.
This cannot be used when the program is opened in
Batch exchanged selected lines are
commented-out.
The selected lines of the comment are batch
released.
Removes all comments in the program.
Arrange all comment in the program.
Edits the program command lines opened in
debugging status.
Inserts the command lines into a program opened in
debugging status.
Deletes the command lines in a program opened in
debugging status.
To Next Page
Loading...
