20-494 20-494
3) Click the [Tool] tab -> [Tact time Calculation] group - [Run calculation] button on the ribbon.
Figure 20-6 Toolbar "Tool" Menu
3. Check the range in which the tact time is to be calculated.
The "Tact calculation" screen for checking the tact time calculation range is displayed. Check the contents of
this range, and click the [OK] button.
Figure 20-7 Checking the Tact time Measurement Range
The tact time calculation is started. During tact time calculation, "Tact time Calculation" is displayed at "Status"
in the simulation operation screen. Do not perform any other operations until this display ends.
Figure 20-8 Simulation Operation Screen During Tact Time Calculation
4. The tact time calculation results are displayed.
When the tact time calculation is completed, the "Tact time calculation results" screen is displayed. The tact
time calculation results are displayed in milliseconds. The tact time calculation results are also displayed in the
output window.
“
To Next Page
Loading...
