21-603 21-603
Figure 21-141 Add joint in user mech. edit tree
21.21.3.1. Object properties
The property item of the user mech. object is the same as the layout object (except for the interference check
item).
Objects added to the user mech. have display conditions individually, and you can display or hide certain objects
by specifying I / O conditions. Please refer to “21.11.3 Layout condition edit”.
Figure 21-142 Add joint in user mech. edit tree
21.21.3.2. Joint properties
Joint name
Set the joint name.
Position
The joint is displayed at the specified position. The position is relative to the position of the parent item. The
setting unit is [mm].
It is possible to set display conditions individually
To Next Page
Loading...
