Start
Switch to the offset/gain setting
mode.
*1
Verify that the mode is set to
offset/gain setting and the RUN
LED is flashing.
Set the offset setting channel in
buffer memory address 22 (Un\G22).
Set buffer memory address 23
(Un\G23) to 0.
Turn the channel change request
(YB) to ON.
*2
Verify that the channel change
completed flag (XB) is ON.
Adjust other
channels?
YES
NO
Set the channel change request
(YB) to OFF.
Set the channel change request
(YB) to OFF.
Turn ON the user range writing
request (YA), and set the offset and
gain.
Register the setting to the Q66AD-DG.
After verifying that the offset/gain
setting mode status flag (XA) is
OFF, turn YA OFF.
Verify that the offset/gain setting
mode status flag (XA) is ON.
Add the current that will be the
offset value.
Set the gain setting channel in
buffer memory address 23
(Un\G23). Set buffer memory
address 22 (Un\G22) to 0.
ERR. LED lit?
YES
NO
End
Verify that the channel change
completed flag (XB) is ON.
2)
1)
2)
1)
Switch to the normal setting mode.
*1
Turn ON the offset/gain change
request (YC).
Make sure that the offset/gain
change completed flag (XC) is ON.
Turn ON the offset/gain change
request (YC).
Add the current that will be the gain
value.
Turn ON the offset/gain change
request (YC).
Make sure that the offset/gain
change completed flag (XC) is ON.
Turn ON the offset/gain change
request (YC).
Turn the channel change request
(YB) to ON.
*2
*3
Set the user range writing request
(YA) to OFF.
To Next Page
Loading...
Need help?
General
