13 - 92
13. POSITIONING MODE
Click the "OK" button to display the setting screen of the single-step feed.
During the servo-on, the following window is displayed to confirm that the operation is in a stop status.
After confirming that the operation is in the stop status, click the "OK" button.
c)
d)
e)
f)
a)
h)
g)
c)
d)
e)
f)
b)
h)
g)
<In point table operation> <In program operation>
(a) Point table No. setting ( a) )
Enter the point table No. into the "Point table No." input field and press the enter key.
(b) Program No. setting ( b) )
Enter the program No. into the "Program No." input field and press the enter key.
(c) Servo motor start ( c) )
Click the "Start" button to rotate the servo motor.
(d) Temporary stop of servo motor ( d) )
Click the "Pause" button to stop the servo motor temporarily.
(e) Servo motor stop ( e) )
Click the "Pause" button again during a temporary stop of the servo motor to clear the travel remaining
distance.
(f) Servo motor restart ( f) )
Click the "Restart" button during the temporary stop to restart the rotations for the travel remaining
distance.
(g) Travel distance clear ( g) )
Click the "Remaining distance clear" during the temporary stop to clear the travel remaining distance.
To Next Page
Loading...
