40/128
T25 System Manual Part 2: Initial Setup without a Computer
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Set Date:
1. Switch on Configuration mode (again, if necessary): Press the OK/MENU button until
you hear the second beep (button flashes blue).
2.
Hold your admin card up to the KeypadRFID buttons until the OK/MENU button lights
up blue continuously.
3.
Switch on Date mode: Press 3 until you hear the second beep and it flashes (reminder:
The letter “d“ on the button stands for “date“).
4. Now enter the current date in the format yyyymmdd (always eight digits long): The
first four digits represent the year (for example, 2012), the next two digits represent
the month (01 for January through to 12 for December) and the last two digits rep
-
resent the day (01 to 31). Confirm your entry by pressing the OK/MENU button.
5.
The respective number buttons on the KeypadRFID light up to show the date (yyyymmdd)
that you have set. The date is also shown on the video phone display after several
minutes.
If you made a mistake when entering the time, repeat steps 1 to 5.
Note
After the date has been displayed, you remain in KeypadRFID Configuration mode for
60seconds, before this mode switches o automatically (if you do not press any more
buttons). Press the ESC/ALARM button to exit the mode immediately.
hold (2nd beep)
OK
hold (2nd beep)
3
OK
0 9
Time Code
To Next Page
Loading...
