Motorola AP-6511

Motorola Solutions AP-6511 Access Point System Reference Guide
8-16
Figure 8-9 WIPS Events screen - Excessive tab
The Excessive tab lists a series of events that can impact the performance of the network. An
administrator can enable or disable the filtering of each listed event and set the thresholds required for
the generation of the event notification and filtering action applied.
An Excessive Action Event is an event where an action is performed repetitively and continuously. DoS
attacks come under this category. Use the Excessive Action Events table to select and configure the
action taken when events are triggered.
10.Set the configurations of the following Excessive Action Events:
Name Displays the name of the excessive action event. This column lists the
event being tracked against the defined thresholds set for interpreting the
event as excessive or permitted.
Enable Displays whether tracking is enabled for each Excessive Action Event. Use
the drop-down menu to enable/disable events as required. A green
checkmark defines the event as enabled for tracking against its threshold
values. A red “X” defines the event as disabled and not tracked by the
WIPS policy. Each event is disabled by default.