Getting Started 1 - 5
•
Four Slot Spare Battery Charger
•
UBC Adapter.
Refer to Chapter 5, Accessories for information on charging a spare battery using an accessory.
Removing the Main Battery
To remove the main battery:
1. Prior to removing the battery, press the red Power button.
On Windows Mobile 6.5 devices, the PowerKey Action window appears. Tap Safe Battery Swap.
2. The Indicator LED Bar lights red.
3. When the Indicator LED turns off, press the primary battery releases. The battery partially ejects from the
MC9190-G.
4. Pause three to four seconds while the MC9190-G performs battery removal shutdown.
5. Press the secondary battery release, on top of the battery, and slide the battery out of the MC9190-G.
Figure 1-3
Removing the Main Battery
Starting the MC9190-G
Press the red Power button to turn on the MC9190-G. If the MC9190-G does not power on, perform a cold boot.
See Resetting the MC9190-G on page 2-22.
1
2
1
3
Primary Battery Releases
Secondary Battery Release
NOTE When a battery is fully inserted in a MC9190-G for the first time, upon the MC9190-G’s first power up, the
device boots and powers on automatically.
To Next Page
Loading...
Need help?
General
