Data Capture 3 - 5
3. Press the trigger or scan button. The captured image appears on the screen.
DataWedge
NOTE By default, DataWedge is not installed on the MC9190-G. Refer to the MC9190-G Integrator Guide for
installation instructions.
Enable DataWedge
To enable DataWedge:
1. On Windows Mobile, tap Start > Settings > System > DataWedge.
On Windows CE, tap Start > Settings > Control Panel > DataWedge.
2. Tap Basic configuration > 1. Barcode input.
3. Tap 1. 1D Scanner Driver or 1. Block Buster Imager.
4. Ensure that a check mark is next to 1. Enabled. If not, tap 1. Enabled.
5. Tap OK.
6. Tap Running to start the DataWedge process. The DataWedge Status changes to Ready.
7. Tap OK.
Disable DataWedge
To disable DataWedge:
1. On Windows Mobile, tap Start > Settings > System > DataWedge.
On Windows CE, tap Start > Settings > Control Panel > DataWedge.
2. Tap the Running option to end the DataWedge process. The DataWedge Status changes to Stopped.
3. Tap OK.
ScanSamp2 Example
To launch ScanSamp2 Example:
1. Tap Start > Programs > Samples.
2. Double-tap Scan icon.
3. Select the scan engine type and tap OK.
To exit the application, tap Cancel.
ImagerSample
To launch ImagerSample:
To Next Page
Loading...
Need help?
General
