Using Bluetooth 4 - 5
Using Microsoft Bluetooth Stack with Windows Mobile 6.5
The following sections provide information on using the Microsoft Bluetooth stack with the Windows Mobile 6.5
operating system.
Turning the Bluetooth Radio Mode On and Off
Turn off the Bluetooth radio to save power or if entering an area with radio restrictions (e.g., an airplane). When the
radio is off, other Bluetooth devices cannot see or connect to the MC9190-G. Turn on the Bluetooth radio to
exchange information with other Bluetooth devices (within range). Communicate only with Bluetooth radios in close
proximity.
Enabling Bluetooth
To enable Bluetooth:
1. Tap Wireless Manager and then tap the Bluetooth bar or
Tap Start > Setting > Connections > Bluetooth icon > Mode tab.
2. Check the Turn On Bluetooth checkbox.
3. Tap ok.
Disabling Bluetooth
To disable Bluetooth:
1. Tap Wireless Manager and then tap the Bluetooth bar or
Tap Start > Setting > Connections > Bluetooth icon > Mode tab.
2. Un-check the Turn On Bluetooth checkbox.
3. Tap ok.
Discovering Bluetooth Device(s)
The MC9190-G can receive information from discovered devices without bonding. However, once bonded, the
MC9190-G and a bonded device exchange information automatically when you turn the Bluetooth radio on. See
Pairing with Discovered Device(s) on page 4-26 for more information.
To find Bluetooth devices in the area:
1. Ensure that Bluetooth is enabled on both devices.
2. Ensure that the Bluetooth device to discover is in discoverable and connectable modes.
3. Ensure that the two devices are within 30 feet (10 meters) of one another.
4. Tap Start > Settings > Connections tab > Bluetooth icon > Devices tab.
5. Tap Add new device. The MC9190-G begins searching for discoverable Bluetooth devices in the area.
NOTE To achieve the best battery life turn off radios not in use.
To Next Page
Loading...
Need help?
General
