MR ETOS ED - Page 276

9 Visualization
Maschinenfabrik Reinhausen GmbH 2020276 6385142/08 ENETOS
®
ED
Limit values for rates of increase
Gas Parameters
Limit 1 Limit 2 Limit 3
H2O (%/d) H2O rate of in-
crease>
H2O rate of in-
crease>>
H2O rate of in-
crease>>>
H2 (ppm/d) H2 rate of increase> H2 rate of in-
crease>>
H2 rate of in-
crease>>>
N2 (ppm/d) N2 rate of increase< N2 rate of in-
crease<<
N2 rate of in-
crease<<<
CO (ppm/d) CO rate of in-
crease>
CO rate of in-
crease>>
CO rate of in-
crease>>>
CO2 (ppm/d) CO2 rate of in-
crease>
CO2 rate of in-
crease>>
CO2 rate of in-
crease>>>
CH4 (ppm/d) CH4 rate of in-
crease>
CH4 rate of in-
crease>>
CH4 rate of in-
crease>>>
C2H2 (ppm/d) C2H2 rate of in-
crease>
C2H2 rate of in-
crease>>
C2H2 rate of in-
crease>>>
C2H4 (ppm/d) C2H4 rate of in-
crease>
C2H4 rate of in-
crease>>
C2H4 rate of in-
crease>>>
C2H6 (ppm/d) C2H6 rate of in-
crease>
C2H6 rate of in-
crease>>
C2H6 rate of in-
crease>>>
O2 (ppm/d) O2 rate of in-
crease<
O2 rate of in-
crease<<
O2 rate of in-
crease<<<
TDCG (ppm/d) TDCG rate of in-
crease>
TDCG rate of in-
crease>>
TDCG rate of in-
crease>>>
Table84: Limit values for the rates of increase