Multicam Laser 2000 Series - Material Cutoff

MI
44
Innovation. Quality. Performance. Best in Industry. Worldwide.
Material Cutoff
The Material Cutoff function is used to manually cut off the remainder of the material being cut in a single,
straight-line or diagonal cutting move using the present Cut Height, Lift Height, Pierce Height, and X & Y
Feedrate.
1. Set up the system as if a normal file is to be executed (e.g., Material Library, Cut Height, Lift Height,
Pierce Height, and X & Y Feedrate). It is not necessary to set home as the cut will begin at the current
X,Y location of the head assembly.
2. Press Jog Arrows
to position the head assembly in the desired start position.
3. Press Menu
to access the menu system.
4. Press X-axis Jog Arrows
until Cut_Utils is highlighted in blue.
5. Press Enter
to access the Cut Utilities sub-menu.
6. Press X-axis Jog Arrows
until Matl_Cut is highlighted in blue.
7. Press Enter
to access the Material Cutoff function.
8. Enter the desired value for the X Cutoff Distance using the number keypad (e.g., 0) and press Enter
.
9. Enter the desired value for the Y Cutoff Distance using the number keypad (e.g., 60) and press Enter .
10. Press X-axis Down Jog Arrow
to access the Dry Run function if needed. This step is optional and
can be skipped.
11. Press Start
to execute Material Cutoff, Cancel to abort the function, or Pause to
reposition the start point.
Cut_Utils Menu
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10