IN
7
Innovation. Quality. Performance. Best in Industry. Worldwide.
Labels
Each machine produced by MultiCam includes certain cautions, warnings, dangers, and notices placed on the
moving parts of the machine (e.g., gantry, carriage) as well as the stationary parts (e.g., electrical enclosure).
These labels are in place to encourage employees to observe safe operating practices at all times. The text on these
labels is almost always capitalized and presented in bold format. Any auxiliary equipment (e.g., vacuum pump,
chiller) will include vendor-specific labels advising the customer of proper safety practices regarding those units
as well. The serial number label is unique to the machine. The most common labels are identified below.
Cautions
Caution labels indicate the potential for minor or moderate injury
and are usually yellow with black writing.
These labels are normally placed on the gantry, axis covers, and any other covers that are located at the front of
the machine.
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10
To Next Page
Loading...
