IN
12
Innovation. Quality. Performance. Best in Industry. Worldwide.
Labels, Warnings, and Cautions
The Federal government requires specific labels, warnings, and cautions to be in place for any laser use or
maintenance, and the State Attorney General’s office, ANSI, and OSHA also require certain forms of notification
regarding the dangers inherent in Class IV Lasers like those available through
MultiCam.
CAUTION – USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
CAUTION – THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD.
Labels
The following labels are used on each laser, and the meaning for each is included.
The statement of conformity is located over the rear cover and guard.
The manufacturer identification is located over the rear cover and guard.
Warnings
Each laser has specific warning labels that are required to be located in specific areas.
The aperture label is located over the front cover and guard.
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10
To Next Page
Loading...
