RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15) — PAGE 13
24 Rammax 1575
1230047 | 21.06.2013
3.1 General working safety
● The roller may only be used for driving on and compacting loose top layers (gra-
vel, earth). Other uses are prohibited.
● Rollers may only be operated with all safety devices operating. Manipulation or
disregard of safety devices and regulations invalidates the CE conformity.
● Before starting every shift, check the effectiveness of the operation and safety de-
vices and that the protection devices are in place.
● Check the steering and brakes when you start work. If defects are apparent, roller
operation is not permitted.
● If you identify any defects on the safety system or defects that impair safe opera-
tion of the equipment, inform your supervisor immediately. The roller may no lon-
ger be operated.
● If you identify any defects which endanger safe operation, cease operation imme-
diately.
● Only perform work on and clean the roller if it is stationary and secured from
rolling away.
● Switch off the engine when filling the fuel tank. Do not fill up fuel in enclosed spa-
ces. No open flames.
● Do not vibrate on slopes or inclines where there is a hazard of slipping or overtur-
ning.
● Do not drive on slopes that are steeper than the maximum climbing capacity of
the equipment. Always drive the roller carefully perpendicular to the slope dip.
● Do not vibrate inside buildings and on unstable ground.
● The driving and working field of view must not be obstructed in any way.
● Switch off the engine before leaving the roller. Secure the roller against unautho-
rized start-up and rolling away.
● Take suitable visible measures to secure parked rollers that pose an obstruction.
● Never work under the influence of drugs, alcohol or medicines that impair consci-
ousness.
● Only operate the roller in good general light conditions and good workspace illu-
mination.
● The workplace of the operator is located at a safe distance of at least 2m.
3.2 Roller operation
DANGER
Rollover hazard when driving the roller!
• Only start the roller using the handheld transmitter.
• Personnel may not stand in front of or behind the roller while it
is in operation.
• Persons necessary for operations at the sides of the equipment
must remain at a safe distance of at least 2 m.
SAFETY INFORMATION
To Next Page
Loading...