RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15) — PAGE 25
Operating and display elements 39
1230047 | 21.06.2013
Battery If the battery charge level control lamp lights up during operation or does not go
off after starting, carry out the following check immediately.
1 Stop the engine.
2 Check the engine for defective or loose V-belt.
If the battery charging lamp is still lit after carrying out these checks, call a specialist.
Engine oil pressu-
re
If the engine oil pressure control lamp lights up during operation or does not go off
after starting, stop the roller and turn off the engine immediately!
1 Check the engine for oil loss and correct oil level.
1.1 The oil level in the engine is correct: Call a specialist to remedy the pro-
blem.
NOTE The machine is equipped with an automatic shutdown system. If the oil pres-
sure falls below the limit value, the oil pressure warning lamp lights up. After
the warning lamp has been lit for 4 seconds, the machine is shut down.
Coolant tempera-
ture
NOTE Danger of engine overheating. Stop immediately!
If the coolant temperature control lamp lights up during operation of the machine,
switch off the engine immediately and top up coolant!
1 Allow the engine to cool down.
2 Remove the radiator cap.
3 In order to avoid scalding, first unscrew the radiator cap one turn and allow the
pressure to drop.
4 As soon as the pressure has dropped, remove the cap and top up the liquid.
5 Check the cooling system for leaks and the radiator/expansion vessel for cor-
rect coolant level.
5.1 You are unable to find an error: Call a specialist to remedy the problem.
NOTE The machine is equipped with an automatic shutdown system. If the cooling
water temperature exceeds the limit value, the temperature warning lamp
lights up. After the warning lamp has been lit for 4 seconds, the machine is
shut down.
WARNING
Danger of scalding! The cooling circuit is pressurized.
OPERATING AND DISPLAY ELEMENTS
To Next Page
Loading...