RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15) — PAGE 81
Repair 103
1230047 | 21.06.2013
If this is not the case, do not under any circumstances attempt to start the engine!
It is possible that there could still be oil in the combustion chambers. Repeat the pro-
cedure described above, or otherwise contact your authorized dealer right away!
If the engine turns over:
1 Check all fluid levels.
1.1 If needed, top up the fluids.
2 Put fuse F 21 back in place.
10.4.3 Start the engine
1. Attempt to start 1 Turn the ignition key clockwise to position III.
1.1a Attempt to start is successful, engine is running: See “Engine is running”
further down.
1.1b Attempt to start is unsuccessful, engine is not running: There could be
air in the diesel system. See “Check the pump” in the following.
Check the pump 1 Turn the ignition key clockwise to position I.
1.1 Check whether the electrical fuel pump is working.
Allow the pump to operate for about 1 minute. The system will be bled automatically.
2. Attempt to start 1 Turn the ignition key clockwise to position III.
2 Allow the engine to turn over in neutral!
2.1 Do not activate any functions.
Engine running The engine will smoke until the oil that has gathered in the exhaust system has been
burned away (can take up to 1h).
1 Immediately perform a visual inspection for any leaking fluids.
If everything is in order:
1 Bring the engine up to maximum speed.
1.1 Check the functions.
WARNING
Danger of fire!
It is possible for flames/glowing embers to be shot out of the
exhaust pipe.
REPAIR
To Next Page
Loading...