MULTIQUIP Rammax Series - If the Outside Temperature Is below 0°C

PAGE 34 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15)
Operation 51
1230047 | 21.06.2013
Fig. 7-2 Start the engine/Infrared sensor
NOTE The control lamps for engine oil pressure and charging light up when the igni-
tion is switched on. They extinguish once the engine is running.
Pre-heating If the outside temperature is below 0°C:
1 Turn the ignition key to position II.
1.1 Hold it in this position for max. 6 sec.
2 Turn the ignition key further to position III.
NOTE The engine is always to be started at idling speed.
NOTE If the ignition key remains at position I and the machine has not yet been star-
ted or has just been shut off, then:
• The machine goes into standby mode automatically after 10minutes.
It is possible at any time to start the machine via the transmitter, using the cable ope-
ration mode or via the ignition switch.
NOTE If the ignition key remains at position I and the machine has not yet been star-
ted or has just been shut off, and no function is activated within 4hours, then:
• The machine controller shuts itself off completely.
To be able to start the machine, the ignition key must first be moved to position 0 brie-
fly.
Standby
OFF
OPERATION