RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15) — PAGE 83
106 Rammax 1575
1230047 | 21.06.2013
11.1 Storage
11.1.1 Short-term storage
● Move the Start/Stop lever on the infrared transmitter to the neutral position.
● Secure the roller from unauthorized start-up and unintentional rolling away.
● Remove the ignition key.
11.1.2 Long-term storage
Tab. 11-1 Long-term storage
Component precautions Chapter
Diesel engine Observe the information in the "Long-term storage" section in the diesel
engine manual.
Fuel (diesel) Drain. 9.7.3
Battery Uninstall the battery and clean the outside.
Charge the battery once a month during standstill time.
10.1
Air filter unit,
exhaust pipe
Cover the air filter unit or its intake opening and the exhaust pipe with adhe-
sive tape. This prevents moisture from getting into the engine.
Hydraulic oil level Drain the hydraulic oil completely. Fill up the hydraulic oil tank with fresh oil
when putting the machine back into operation.
9.9
Steering cylinder Lubricate the bearings of the steering knuckle and the front bearing of the
steering cylinder with grease.
Lubricate the piston rod of the steering cylinder with grease guard.
9.12
Infrared transmitter Always move the “Start/Stop” switch to the Stop position.
STORAGE
To Next Page
Loading...
