MULTIQUIP Rammax Series - Transport; Articulated joint locking for transport

PAGE 84 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15)
108 Rammax 1575
1230047 | 21.06.2013
12.1 Transport
12.1.1 Shipping weights and dimensions
Tab. 12-1 Shipping weights and dimensions
12.1.2 Joint protection
Articulated joint
blocking
1 Release the lower part of the joint protection (1).
1.1 First, remove the compression spring (2) and then the lock bolt (3).
2 Carefully turn the roller steering until the joint protection comes in line with the
opposite loop.
NOTE In order to operate the steering, you must start the roller and maintain a distan-
ce of at least 2meters.
3 Hook the joint protection into place.
4 Secure the joint protection with the lock bolt (3).
5 Secure the lock bolt with the compression spring (2).
Rammax 1575
Roller drum width (mm) 640 850
Shipping weight (kg) 1400 1450
Dimensions: L x W x H - without shutdown bar (cm) 200 x 64 x 132 200 x 85 x 132
Dimensions: L x W x H - with shutdown bar folded upwards (cm) 205 x 64 x 132 205 x 85 x 132
DANGER
Risk of crushing through presence in the pivoting area (dan-
ger zone)!
• The articulated joint lock (joint protection) must be fitted before
lifting the roller for transport.
• Be certain that no persons are present in the area of the joint
protection.
!
DANGER
Risk of crushing through presence in the pivoting area (dan-
ger zone)!
• As soon as the roller is aligned, shut if off again.
!
TRANSPORT