NEC SL1100 - Page 110

Program Num-
ber
Program Name Default
11-10-08 Service Code Setup (for System Administrator) - Setting
the Destination for Automatic Trunk Transfer
735
13-01-01 Speed Dialing Function Setup - Speed Dialing Auto Outgo-
ing Call Mode
0
13-04-01 Speed Dialing Number and Name - Speed Dialing Data not assigned
14-01-26 Basic Trunk Data Setup - Automatic Trunk-to-Trunk Trans-
fer Mode
0
20-06-01 Class of Service for Extensions Extension 101 is Class 15 and other
Extension are Class 1
20-07-05 Class of Service Options (Administrator Level) - Set/Cancel
Automatic Trunk-to-Trunk Transfer
COS 01 ~ 15 = 0
22-02-01 Incoming Call Trunk Setup - Incoming Type 0
24-02-11 System Options for Transfer - No Answer Step Transfer 10 (seconds)
24-02-12 System Options for Transfer - No Answer Trunk-to-Trunk
Transfer
0 (seconds)
24-04-01 Automatic Trunk-to-Trunk Transfer Target Setup 999
Trunk-to-Trunk Forwarding - DID (3) Trunk Forwarding by Department Groups
Refer to Departmental Calling on page 1-193 for additional Department Group programming.
Program Num-
ber
Program Name Default
11-07-01 Department Group Pilot Numbers - Dial not assigned
11-11-25 Service Code Setup (for Setup/Entry Operation) - Automat-
ic Transfer Setup for Each Extension Group
602
11-11-26 Service Code Setup (for Setup/Entry Operation) - Automat-
ic Transfer Cancellation for Each Extension Group
603
11-11-27 Service Code Setup (for Setup/Entry Operation) - Destina-
tion of Automatic Transfer Each Extension Group
604
13-01-01 Speed Dialing Function Setup - Speed Dialing Auto Outgo-
ing Call Mode
0
13-04-01 Speed Dialing Number and Name - Speed Dialing Data not assigned
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for Confer-
ence and Transfer Calls
32 (0 dB)
14-01-05 Basic Trunk Data Setup - Receive Gain Level for Confer-
ence and Transfer Calls
16 (-8 dB)
14-06-01 Trunk Group Routing - Priority Order Number Route 1, Order Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4 = 0 (Not Speci-
fied) All Other Routes (2 ~ 25) and Or-
der Numbers (1 ~ 4) = 0 (Not Specified).
15-07-01 Programmable Function Keys Refer to Programming Manual.
16-02-01 Department Group Assignment for Extensions All extensions in
Department Group 1 with priority in port
order:
Port 1 priority = 1
Port 84 priority = 84
20-06-01 Class of Service for Extensions Extension 101 is Class 15 and other Ex-
tension are Class 1
20-11-17 Class of Service Options (Hold/Transfer Service) - Depart-
ment Group Trunk-to-Trunk Transfer (Each Telephone
Group Transfer)
COS 01 ~ 15 = 1
SL1100 ISSUE 2.0
1-98
Call Forwarding, Off-Premise
C