5. Dial the number you want to call.
To dial an outside number and let your system tell you when a Forced Account Code
is required:
1. Access a trunk and dial the number you want to call.
2. Wait for your call to go through.
- OR -
3. If you hear “Please enter an Account Code,”(depending on system programming) and your
display shows ENTER ACCOUNT CODE.
• Dial
.
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
• Dial your Account Code (3~16 digits, using 0~9 and #).
If Account Codes are hidden, each digit you dial shows an
on the telephone display.
• Dial
.
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
To enter an Account Code for an incoming call:
This procedure is not available for Single Line Terminals.
1. Answer incoming call.
If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected
trunk.
2. Dial
.
3. Enter the Account Code (1~16 digits).
You can enter any code of the proper length.
4. Dial
.
To enter a Forced Account Code at a Single Line Terminal:
1. Access trunk for outside call.
You can access a trunk by dialing a code. Refer to Central Office Calls, Placing for more information.
With Forced Account Codes, you hear, “Please enter an Account Code.”(It depends on
programming).
2. Dial
.
3. Enter Account Code (3~16 digits).
4. Dial
.
5. Dial number you want to call.
ISSUE 2.0
SL1100
Features and Specifications Manual 1-17
A
To Next Page
Loading...
