NEC SL1100 - Page 540

Conditions
Only 1 VRS prompt message (2 minutes in length) can be recorded in a flash memory on CPU unit.
This VRS prompt message can be used for HOLD message.
Default Settings
Disabled
System Availability
Terminals
None
Required Component(s)
None
Related Features
Analog Communications Interface (ACI)
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
Number
Program Name/Description Assigned Data
10-04-01 * Music on Hold Source Selection
Assign the systems Music on Hold Source.
0 = Internal MOH (Tone set by PRG
10-04-02)
1 = External MOH (Tone set by PRG
10-60-01: Audio Port No.2)
2 = Service Tone (Tone set by PRG
80-01, tone 64)
3 = VMDB (Tone set by PRG
10-04-02)
(default = 2)
10-04-02 Music on Hold Tone Selection
Select the different internal tones that can be played.
If PRG 10-04-01 is a (0) then the following settings apply:
1 = Farewell Song
2 = Die Forelle
3 = Plaisir d'amour
If PRG 10-04-01 is a (3) then the following settings apply:
1 ~ 100 = VRS Message Number 1 ~ 100
1 ~ 100
See the description setting for more
details.
(default = 1)
10-04-03 Audio Gain Setup
Use this program to adjust the volume of the internal Music on Hold
source.
1 ~ 63 = -15.5 ~ +15.5 dBm
(default = 32 which is 0 dBm)
SL1100 ISSUE 2.0
1-528
Music on Hold
M