NEC SL1100 - Page 796

Program Num-
ber
Program Name Default
80-04-09 Call Progress Tone Detector Setup - OFF maximum time Type 1 (DT) = 1 (60ms)
Type 2 (BT) = 20 (630ms)
Type 3 (RBT) = 115 (3480ms)
Type 4 = 0
Type 5 = 0
Operation
Calling your Mailbox
To call your mailbox:
Multiline Terminal
1. Press your Voice Mail key (PRG 15-07 or SC 751: 77).
- OR -
Press Speaker key and dial the Voice Mail Master Number. After Voice Mail Answers, dial your
mailbox number.
Your mailbox number is normally the same as your extension number. You may optionally dial a co-
worker’s mailbox - or use this procedure to call your mailbox from a co-worker’s telephone.
2. If requested by Voice Mail, enter your security code.
Ask your Voice Mail system administrator for your security code.
Normally, your Message Waiting LED goes out (if applicable). If it continues to flash, you have
unanswered Message Waiting requests or a new General Message.
Single Line Terminal
1. Lift the handset and dial
*
8.
If you are at a co-worker’s telephone, you can dial the Voice Mail master number and your mailbox
number instead. You can also use this procedure from your own telephone to call a co-worker’s
mailbox.
2. If requested by Voice Mail, enter your security code.
Recording your Call
To record your active call in your mailbox:
Multiline Terminal
1. Press the Voice Mail Record key (PRG 15-07 or SC 751: code 78).
You hear two beeps and your Record key flashes. The beeps periodically repeat to remind you that
you are recording.
To stop recording, press the Voice Mail Record key again. You can restart and stop recording as
required.
- OR -
1. Press Hold key.
SL1100
ISSUE 2.0
1-784
Voice Mail Integration (Analog)
V