NEC SL1100 - Page 853

To program a key, press Speaker key, dial 751 (for 2-digit codes) or 752 (for 3-digit codes), press the key
and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you ... Key Lamp Status Also see Srvc
Code
Note
Code: 44
Operation: Place
or answer call +
Press key
Hold Put a call on Sys-
tem Hold (if Hold
key is reassigned).
None -
Code: 45
Operation: Place
or answer call +
Press key
Put a call on Exclu-
sive Hold.
None -
Code: 46
Operation: Press
key
Department Calling Log in or log out of
your Department
Calling Group.
On when removed, Off
when installed
650
Code: 47 + dest.
ext.
Operation: Press
and hold key
Reverse Voice Over Initiate Reverse
Voice Over.
Full BLF red -
Code: 48
Operation: Hear
Off-Hook Signal-
ing tones + Press
key
Voice Over Initiate or respond
to Voice Over.
On red when respond-
ing Hold Flash red
when listening
690
Code: 49 + ext or
voice mail number
Operation: Press
key
Call Redirect Redirect an incom-
ing call to an exten-
sion or voice mail.
On red when activated
Flashes when in DND/
Call Forward
-
Code: 50
Operation: Press
key
Account Codes Enter Account Co-
des.
None
*
or ##
Code: 55
Operation: Do not
Lift the handset +
Press key + Enter
extension number
+ Enter name +
Press Hold
Name Storing Change the name
displayed on your
display telephone.
None 700
Code: 83 + 0~4
Operation: Press
key
Voice Mail Use Voice Mail
Service.
Flashes slowly when
monitoring
-
Code: 77 + exten-
sion or Message
Center number
Operation: Press
key
Call Voice Mail or
leave a message.
Flashes green on your
key for your messages
or flashes red for the
Message Center
*
8 or 8
Code: 78 + Con-
versation Record
Operation: Press
key
Use Conversation
Record.
Flashes red when re-
cording
-
Code: 79 + ext or
pilot number
Operation: Press
key
Voice Mail Use Automated At-
tendant.
On when setup for All
calls.
Slow flash when setup
for Busy/No answer
calls.
-
Code: 80 + ext
number
Operation: Press
key
Tandem Ringing Set up Tandem
Ringing
On for Master Side.
Slow flash for Slave
Side.
not assigned
Code: 81 + trunk
line 001 ~ 76
Operation: Press
key
Automatic Transfer
to Transfer
Set up Automatic
Transfer to Transfer
Slow Flash when set. 833
ISSUE 2.0 SL1100
Features and Specifications Manual 2-23