NETGEAR ProSafe GS108 User Manual

GS108T Smart Switch Software Administration Manual
Managing System Settings 3-23
v1.0, May 2007
.
The following LLDP remote information is displayed:
• Local Port: Port on which LLDPDU was received.
• Chassis ID SubType: Indicates the basis for the Chassis ID entity.
• Chassis ID: Identifier for the particular chassis in the System.
• Port ID SubType: The basis for the identifier that is listed in the Port ID field.
• Port ID: Identifier for the port from which LLDPDU was transmitted.
The following LLDP Remote Device Information is displayed:
• Port ID SubType: The basis for the identifier that is listed in the Port ID field.
• Port ID: Identifier for the port from which LLDPDU was transmitted.
• PVID: Port VLAN ID.
Figure 3-18
Table 3-5. 802.3 Set Details
Item Description
Auto Negotiation If auto-negotiation supported and enabled in both the systems, there should be
no speed difference.
Aggregator Status Ports through which LLDPDU is transmitted is aggregated or not.

NETGEAR ProSafe GS108 Specifications

General

MAC address table	8000 entries
Maximum data transfer rate	1 Gbit/s
Full duplex	Yes
Networking standards	IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Latency	20 μs
Dimensions (WxDxH)	235.5 x 100.8 x 27 mm
Power requirements	5 V @ 2.8 A DC
Networking features	Ethernet, Fast Ethernet, Gigabit Ethernet
Switch type	Unmanaged
Basic switching RJ-45 Ethernet ports quantity	8
Noise level	0 dB
Mean time between failures (MTBF)	91.500 h
Power consumption (typical)	14 W
Safety	UL (UL 1950), CUL, C-Tick
LED indicators	Link, Power
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	760 g